HITEC Flash7, Инструкция по эксплуатации, Страница: 15 / 52

7 Channel 2.4 GHz Aircraft Computer Radio System 7 Channel 2.4 GHz Aircraft Computer Radio System
Section 2: Quick Start Guides Section 2: Quick Start Guides
26 27
Airplane Quick Start Guide
6. When asked to create a new model select “Yes.” This will bring
up the Model Type screen.
Scroll to Acro/Glid” or “Select Acro/Glid.
Now scroll to “wing” and press the jog dial to activate the
choices. If you have 1 aileron servo select 1AILE, if your plane
has two aileron servos select 2AILE. Press the jog dial once to
confirm your selection.
7. Next, select your plane’s tail type. Select “Normal” and press
the jog dial once to confirm your entry .
8. Now press the back button once. You will be prompted to
choose the receiver type. Press the jog dial once to activate
the receiver selections and scroll to the receiver you have in
your aircraft. Press the jog dial once to confirm your receiver
selection.
We are programming a new model into the model memory slot number two, not the model
memory slot one. For the purpose of this exercise it will ensure a fresh model memory with no
existing programming.
Note
Tip Tip
Tip
Depending on what you select here, and for the following menu choices, the radio will
automatically optimize the functions for your choices. In other words, if you select a wing type
without flaps, there will be no flap function control in that model memory’s programming
selection.
Note
Tip Tip
Tip
Airplane Quick Start Guide cont.
9. Turn your transmitter off and then back on. When prompted to transmit this time select “Yes.” You are
now ready to fly a simple model with basic settings. If a more complex setup is needed refer to sections
4 and 5 for more detailed programming instructions.
Helicopter Quick Start Guide
The following information is designed to guide you through a simple setup of a basic 120 cyclic collective
pitch mixing (CCPM) helicopter with a fly bar. The operations shown during this exercise will help you
understand many of the basic programming steps used by the Flash 7 when programming a basic
helicopter setup.
Channel Assignments
Channel 1 – Roll Cyclic / Aileron
Channel 2 – Pitch Cyclic / Elevator
Channel 3 – Throttle
Channel 4 – Tail Rotor Pitch / Rudder
Channel 5 – Gyro Function
Channel 6 – Collective Pitch
1. Turn on the transmitter; do not turn on the helicopter.
2. When prompted if you are “ready to transmit” select “No.”
3. Press the jog dial and back button simultaneously to enter the
System Menu list.
4. From the System Menu list choose MDL.SEL to enter the
model setup.
If your receiver is not bound/linked to your transmitter you will need to follow the procedures
on pages 18-19 to do so.
Warning
Note
Tip Tip
Tip Caution