Higen FDA7000 Series, Руководство по эксплуатации

Страница: 37 / 214

1. Model check and handling
1-30
A. Electric shock prevention
Danger
!

Do not open the cover of servo drive while energizing and driving. It may cause electric shock.

Do not operate with the cover of servo drive removed.
High voltage terminals and charging parts are exposed, which may cause electric shock

Do not remove the surface cover except wiring and regular inspections immediately after the
power is turned off.
The inside of servo drive is charged and may cause electric shock..

Wait 10 minutes or more after turning off the power and check the charging lamp is turned off
before wiring and checking.

Connect the ground terminal of the earth and the motor to the ground terminal of the drive with
the shortest distance.
Connect to Class 3 ground (100 ohm or less) to prevent electric shock and product
malfunction.

Wiring and inspection should be done by a qualified technician.

Install the product before wiring. It may cause electric shock or injury.

Do not touch the servo drive with wet hands. It may cause electric shock or injury.

Damaged wires can result in electric shock.
Do not place heavy objects on the wires or pull the wires forcibly.
B. Fire Protection
Caution
!

Install the servo motor, servo drive and regenerative resistor on non-flammable materials.
Installation on or near flammable materials may cause fire.

If the servo drive is broken, immediately turn off the power of the servo drive.
If a large amount of current continues to flow, it may cause a fire.

If overload and overcurrent occur frequently, be sure to cool the servo motor and servo drive
sufficiently before restarting.

If an overvoltage alarm occurs frequently, the regenerative resistor may overheat and cause a
fire. If overvoltage alarms occur frequently or do not clear, immediately shut off power.