HGG SPC 1000, Руководство оператора, Страница: 90 / 169

Calibration
Software calibration of the cutting head
The software calibration of the cutting head can be found on the ‘Diagnostics’ screen of the remote
control. Follow the instructions below to calculate and enter the offsets and complete the software
calibration.
● Remove both side covers to reveal the cutting head.
● On the remote control touch screen select the ‘Diagnostics’ tab.
● On the ‘Diagnostics’ screen, select the ‘Cutting head’ tab.
● At the top left of the screen you will see the ‘Cutting head
calibration’ dialogue. To carry out the calibration you will
need a retractable measuring tape.
Calibrate
tilt
Calibrate
rotation
Store
offsets
Free
tilt axis
Free
rotation axis
Tilt offset
● Press the ‘Calibrate tilt’ button in the calibration control box. When the
cutting arm has stopped moving a notification will appear on screen
“Cutting head tilt axis is free. Please position the axis at its ‘home’
position.”
● Manually move the cutting head so that the top calibration pin can be
inserted.
● Store the offset by pressing the ‘Store offsets’ button.
Torch angle
The calibration of the torch angle is done mechanically. The torch angle
calibration is included here for convenience because the tilt offset also
involves alignment with the calibration pins. The upper calibration pin fits so
the torch is in line with the cutting head arm. The torch holder must also be
in line with the arm. This can be adjusted as follows:
● Make sure the upper calibration pin fits
● Unscrew the bolt “216” at the back of the torch holder and nut type “K4”
the torch holder can now be tilted manually
● Rotate the torch holder until the lower calibration pin fits
● Secure the nut “K4” (not too tight)
● Secure the bolt “216” while the calibration pin is inserted
● Remove both calibration pins before calibrating the rotation offset.
CALIBRATION
Top
Bolt 216 Nut K4