HGG SPC 1000, Руководство оператора, Страница: 62 / 169

Operators Manual
Pipe Profiling Machine | SPC 500-1200
54
SPC
The ‘Displace profile’ button – continuing from a new position
Pressing the ‘Rewind’ or ‘Fast forward’
buttons or rotating the main drive when
the machine is paused will move the
cutting trolley along the pipe (CTL axis)
or rotate the pipe (MDR axis). This
automatically activates the ‘Displace
profile’ button in the right hand quick
action buttons.
The action progress section at the bottom
of the profiling screen will show the
‘Not in position’ prompt. Pressing the
‘Displace profile’ button will move the
cutting head to the new position and the
action progress will show the ‘Start tool’
prompt. Press ‘Play’ to continue from the
new position. Instead of pressing the
‘Displace profile’ button, press the ‘Play’
button again to return to the position
where the machine was paused.
1 On the remote control, press the
‘Pause’ button to interrupt the cutting
process.
2 Move the cutting head or rotate the
pipe to the new position with the
quick action buttons.
3 Press the ‘Displace profile’ button to
continue from the new position.
4 Press the ‘Play’ button to resume
profiling.
WARNING!
Changing the cutting position will affect the whole job! All remaining profiles are
calculated from the new position!
To cut near the main drive
When the cutting trolley comes close
to the main drive a warning will appear
on the screen. This safety feature is to
prevent damage from a possible collision
with the main drive. When the safety
area is reached the cutting trolley will
stop. It is possible to continue by de-
activating the safety using the toggle
button at the bottom right of the screen.
When the safety is de-activated the ‘Fast/
slow’ toggle button is automatically set to ‘Slow’ and the button is disabled (it is
not possible to return to ‘Fast’ while not
in safety mode). It is now possible to
continue, slowly. When the safety mode
is re-activated the speed remains set
to ‘Slow’ but the ‘Fast/slow’ button will
once again become active and the speed
can be changed back to ‘Fast’ when and
if required. When the machine is set to
slow, the cutting trolley moves at one
fifth of the speed.
CAUTION!
When the safety is disabled and the machine moves at slow speeds, it is still possible
to run the cutting head into the main drive. This can and probably will cause damage
to the cutting head! Operators must always keep safety in mind!