HGG SPC 1000, Руководство оператора, Страница: 9 / 169

Operators Manual
Pipe Profiling Machine | SPC 500-1200
1
SPC
Figure 1: Nameplate pipe profiling machine Figure 2: Nameplate pipe trolley
Introduction
Pro fi le
Machine Minimum and maximum
outer diameter Maximum
weight Minimum
length Maximum
length
CHS
(Circular
Hollow
Section)
SPC 500 48 mm 510 mm 4000 kg 300 mm 6000 mm
SPC 600 48 mm 610 mm 4000 kg 300 mm 6000 mm
SPC 800 60 mm 815 mm 6000 kg 300 mm 6000 mm
SPC 1000 75 mm 1020 mm 8000 kg 300 mm 8000 mm
SPC 1200 75 mm 1225 mm 8000 kg 300 mm 12000 mm
SPC 1200 75 mm 1225 mm 12000 kg 300 mm 12000 mm
Cutting
process Minimum wall thickness Maximum wall thickness Cutting angle range
Oxyfuel 3 mm 150 mm -70° tot 70 °
Plasma 3 mm 38 mm (30 mm quality cut) -45° to 45°
Intended use of the machine
This machine is a thermal profiling machine and should be used for profiling steel pipes with an oxygas
cutting process (oxyfuel) or plasma cutting process. For the explanation of these two processes, see
the ‘Terminology’ appendix. The machine should be used for industrial applications only. The machine
is suitable for cutting the pipe range as described in the technical specifications or the nameplate. An
overview of the pipe ranges is shown in the table below.
A nameplate like the one shown in Figure 1 is located on the side of the main drive unit. A nameplate like
the one shown in Figure 2 is located on the front side of each pipe trolley. You should always keep these
nameplates clean and legible.
Pipe range SPC 500 - 1200