HGG SPC 1000, Руководство оператора, Страница: 29 / 169

Operators Manual
Pipe Profiling Machine | SPC 500-1200
21
SPC
Profiling mode
The ‘Profiling’ option is activated when
a data file is loaded. In profiling mode
the buttons change to allow adjustment of cutting speed and plasma power and
other controls relating to the profiling
process. See below for more details.
During profiling the cutting
speed buttons will appear. Left:
increase profiling speed, right:
decrease profiling speed. When profiling using plasma,
these buttons allow the
operator to manually increase
or decrease the plasma power.
This button disables the cutting
tool allowing its movement to
be checked before cutting (left:
dry run off, right dry run on,
cutting tool disabled). The ‘Dry run’ button. When
profiling with oxyfuel these
buttons enable and disable the
‘Dry run’ mode (see description
on the left for plasma).
If the pipe is rotated while
profiling is paused, this button
resumes from the new position
(pressing play will resume from
where profiling was paused). When profiling using oxyfuel
this button toggles between
preheat enabled and disabled.
Automatic mode
If ‘Automatic’ mode is available on your
machine this button will also appear in
the ‘Mode selection’ window. This will add
the four buttons shown below to the side
bar. When ‘Automatic profiling’ is enabled the top four buttons of the side bar will
change to those shown in the bottom
table on this page. The ‘Mode selection’
button will be disabled during ‘Automatic
profiling’.
Home all axes. The main drive,
cutting trolley and cutting head
axes move to their ‘Home’
positions. Start/continue automatic
infeed.
Enable/disable automatic
profiling. Start/continue automatic
outfeed.
During automatic profiling thes buttons appear in the top four positions:
Increase cutting speed. Increase plasma power.
Decrease cutting speed. Decrease plasma power.