360179-A/B
34
Maintenance & Service
Clean painted interior surfaces:
1
Apply mild detergent solution to the painted interior surfaces.
2
Using a cotton cloth, wipe the interior surfaces dry.
Clean stainless steel interior surfaces:
1
Apply general-purpose laboratory cleaner to the stainless steel interior surfaces.
2
Using a cotton cloth, wipe the interior surfaces dry.
9 .6 .5
Door Gaskets
NOTE
Avoid getting water in the Access Control magnetic lock.
Required tools:
►
Soft cotton cloth (2)
►
Mild soap and water solution
Clean the door gaskets:
1
Using a soft cotton cloth, apply soap and water solution to the door gaskets and gasket crevices.
2
Using a second clean and dry cotton cloth, wipe the door gaskets clean.
9 .6 .6
Clean the Tray Assembly
NOTE
►
Refer to
Section III, Item 10 .3 .1,
for instructions on removing the tray from the
compartment assembly.
Required supplies:
►
Soft cotton cloth
►
Mild detergent solution
Clean trays and covers:
1
Apply mild detergent solution to the tray and cover.
2
Using a cotton cloth, wipe the tray and cover dry.
9.6.7
Clean Probe Bottle and Refill Solution
Required supplies:
►
Fresh water-bleach solution
►
1:10 ratio of bleach to water
►
Bleach is 5% solution of commercial sodium hypochlorite (NaOCl) (Equivalent oxidizing cleaner/
disinfectant approved by your organization may be substituted)
►
4 oz. (120 mL) of product simulation solution per bottle
►
10:1 ratio of water to glycerin
Clean and refill bottle:
1
Remove probe(s) from bottle.
2
Remove bottle from bracket.
3
Clean bottle with water-bleach solution.
4
Rinse bottle thoroughly with tap water.
5
Fill bottle with 4 oz. (120 mL) of product simulation solution.
6
Cap bottle tightly to minimize evaporation.
7
Place bottle in bracket.
8
Replace probe(s), immersing at least 2” (50 mm).
