Harris QSEE6800 Plus H, Инструкция по установке и эксплуатации

Страница: 28 / 86

14 QSEE6800
+
H Installation and Operation Manual
Chapter 2: Installation
Upgrading Module Firmware
Firmware upgrading is a routine procedure that you must perform to
install newer versions of software on 6800
+
modules. Pilot, Co-Pilot, or
Navigator software version 3.1.1 or later is required for this procedure.
The frame must contain or be connected to another frame that contains
an ICE6800
+
module.
You can use either the Discovery or the drag-and-drop method. When
performing the upgrading procedure, check the appropriate readme file
to confirm which files are needed. Use care to ensure that you upload
the correct files to the intended module.
In the unlikely event that an upgrade fails, the module may not respond
to controls and will appear to be non-functional. In that event, follow
the procedures described in
“Correcting a Failed Upgrading Procedure”
on page 17 .
Upgrading the Firmware
Upgrading the Firmware Using the Discovery Method
Follow these steps to upgrade the firmware:
1. Download the most recent appropriate upgrade package from our
Web site or from your CD-ROM.
2. If the affected module has not been discovered in CoPilot, Pilot or
Navigator, perform the Discovery operation, as described in your
CCS software application manual or online help. (If you cannot
discover the device, see
“Upgrading Firmware Using the
Drag-and-Drop Method” on page 16 .)