Harman Martin Exterior Projection 1000, Руководство пользователя

Страница: 49 / 60

Exterior Projection 1000 User Manual 49
Fixture
Config
Master/Slave Master /Slave
Fixture acts as master or slave in master/slave
operation
Set only one fixture to be master!
Offline mode
Run show
When no DMX signal is present, fixture runs
standalone show
DMX last state
When no DMX signal is present, fixture displays
the last effect it was displaying before the DMX
signal stopped
Black out
When no DMX signal is present, fixture blacks
out
Service
Fixture status
LED Temperature Temperature of LED engine in °C
Power-on Hours
Number of hours fixture has been powered on
since manufacture
Lamp Hours
Number of hours light output has been
activated since manufacture (or since counter
last reset).
Press Enter, then use service password (123) to
access option to reset lamp hours to zero
Software Version V x.x.x
Currently installed software
(firmware) version
Fixture offset
Cyan -128~127 Note: For use by Martin
Service!
Enter user password
(default = 123) or service
password (111) for access
to effect offsets. Then set
an offset in each effect’s
home position.
Magenta -128~127
Yellow -128~127
Color Selection -128~127
Etc… …
Evaporation mode Password 0 … 999
Enter user password (default = 123) or service
password (111) to put fixture into Evaporation
Mode. To clear humidity, open top cover slightly,
then press Enter. When message to close cover
appears in display, close top cover, then press
Enter.