Harman Martin Exterior Projection 1000, Руководство пользователя, Страница: 10 / 60

10 Exterior Projection 1000 User Manual
Transporting the fixture
Important! If you need to transport the fixture after you have removed the temporary cable ties
that new fixtures are supplied with to protect them during delivery (see point 6. in the previous
section), you must open the top cover and install a temporary protection spring inside the fixture.
Installing the spring locks the frost car at the back of its movement range so that components are
protected from damage caused by movement during transport.
A transport protection spring is supplied with each fixture but you can also obtain the spring as an
accessory for the Exterior Projection 1000 by ordering P/N 91611097 from your Martin supplier.
To install the transport protection spring:
1. Open the top cover as described in ‘Removing and reinstalling the top cover’ on page 36.
2. See illustrations below. Pull the frost car back as far as it will go from the front of the fixture by
pulling on the metal frame of the car with your finger. Then hook the short end of the transport
protection spring through the circular hole (arrowed) in the metal frame of the frost car.
3. See illustrations below. Using a pair of flat-nosed pliers, hook the long end of the spring
around the turret nut (arrowed) on the effects module. Check that the transport protection
spring holds the frost car securely at the rear limit of the frost car’s travel.
4. Finally, reinstall the top cover as described in ‘Removing and reinstalling the top cover’ on
page 36.
Important! Before using the fixture after transport, you must open the top cover and remove the
spring. Leave a message on the fixture for the person who will unpack or install it, warning them
that they must remove the spring before the fixture is used.