Harman Martin Exterior Projection 1000, Руководство пользователя, Страница: 15 / 60

Exterior Projection 1000 User Manual 15
To adjust the aim of the fixture:
1. Set the fixture to a gobo with a sharply defined pattern.
You can select the image remotely either via DMX or by
using the MANUAL TEST menu in the fixture’s control
panel.
2. Put on heat-resistant gloves.
3. See illustration on right. Loosen the tilt lock Allen (hex)
screws (arrowed) on both sides of the yoke slightly, just
until you can tilt the fixture in the yoke.
4. See ‘Anchoring to a surface or structure’ on page 13. In
the base of the mounting yoke, loosen the bolts in the
center hole
A and curved slots C slightly, just until you
can rotate the yoke.
5. Pan and tilt the fixture until it is aimed correctly.
6. Using a torque driver, tighten the four tilt lock screws to a torque of 1.8 – 3.5 Nm.
7. In the base of the mounting yoke, tighten the bolts in the center hole A and curved slots C and
install bolts in holes B . Check that the fixture will be held securely in all wind and weather
conditions.