Harman Martin Exterior Projection 1000, Руководство пользователя

Страница: 21 / 60

Exterior Projection 1000 User Manual 21
3. The fixture’s current DMX address is displayed. Press UP or DOWN to scroll to the DMX
address that you want to give to the fixture.
4. Press ENTER to store the DMX address in the fixture.
5. Press MENU to exit.
Programming a standalone show
You can program a standalone show – a sequence of ’scenes’ that run in a loop – in the Exterior
Projection 1000. A scene consists of a combination of effects such as gobo selection, gobo
movement, color, intensity, etc. You can set the standalone show to run if you are not using a DMX
controller or if a signal from a DMX controller is lost. The show can have up to 20 scenes that
display for up to 10 minutes each. You can program ’fades’ (changes from one scene to the next)
so that scenes change immediately or change gradually over a period of up to 120 seconds’
duration.
Note: To enable standalone operation, the OFFLINE MODE setting in the FIXTURE CONFIG
menu must be set to RUN SHOW. See ’Offline mode – behavior when no DMX or Master signal is
received’ on page 24. A fixture will only run a standalone show when it is not receiving a DMX
signal.
To program a stand-alone show:
1. Access the control menu and use UP and DOWN to scroll to PROGRAM SHOW. Press
ENTER to select.
2. Set the total number of scenes:
a. Select SET SCENE TOTAL and press ENTER.
b. Use UP and DOWN to select from 1 to 20 scenes.
c. Press ENTER.
3. Modify the appearance of scenes:
a. Select EDIT SCENE and press ENTER.
b. Select the scene that you want to modify and press ENTER.
c. Select the effect that you want to adjust (Strobe, Dimmer, Cyan, Magenta, Yellow, Color
Selection, Gobo Selection, Gobo Ind/Rot, Animation Index, Animation Rotation, Frost,
Prism, Prism Rotation, Zoom, Focus) and press ENTER.
d. Press UP or DOWN to scroll to a value. When satisfied, press ENTER to confirm your
selection.
e. Repeat steps c) and d) for each effect.
f. Press MENU to go back up one level in the menus and select another scene to modify.
g. When done editing scenes, press MENU again to return to the PROGRAM SHOW menu.
4. Set the length of time each scene is displayed before fading to the next scene and set the
length of time one scene fades to the next scene:
a. Select SET SHOW TIMES and press ENTER.
b. Select SET HOLD TIME and press ENTER. Press UP or DOWN to scroll to scene
duration from 0 to 600 seconds. Press ENTER to confirm your selection.
c. Select SET FADE TIME and press ENTER. Press UP or DOWN to scroll to a scene
change fade duration from 0 to 120 seconds. Press ENTER to confirm your selection.
5. Press MENU to exit.
Manual control mode
The fixture can be tested, reset and returned to default factory settings manually from the control
panel. To enter manual mode:
1. Access the control menu and select MANUAL MODE.
2. Press ENTER.