– 10 –
(
Continued next page
)
Start/Pause
Press
Start
to begin the cycle.
NOTE
: Unless Bulky cycle is selected, the lid must be closed
for the washer to start cycle. If the lid is open, “Lid” will scroll across the display. During the
load sensing portion of the cycle, the lid will lock, and “SEnSing” will scroll across the display.
When load sensing is complete, the lid will unlock.
Pressing
Pause
will unlock the lid (if locked at that time), pause the cycle and the
Start
indi-
cator light will blink.
To continue the cycle, press
Start
again. If water remains in the machine, select the
Drain
and Spin
cycle to drain basket and spin water out of the washer basket.
NOTE
: Machine will
automatically cancel and drain when water is present, and the lid is left open for 15-minutes
or the unit is left in a paused state for 24-hours with the lid closed. Select cycle and press
Start
to begin new cycle.
Display and Status Lights
Display
: The display shows the
approximate
time remaining until the end of the cycle.
NOTE
: The cycle time is affected by how long it takes the washer to fill. This depends on the
water pressure in the home. The size of the load being washed also significantly impacts
cycle time, with larger loads taking longer.
In addition, this display will, “scroll” the washer status:
•
BALANCING
Start of rebalancing cycle to redistribute clothes. Stops after rebal-
ancing is complete.
•
DELAY
When Delay Wash is initiated. Replaced with estimated time when
cycle starts.
•
End
End of current cycle.
•
FILL
“FILL” will scroll across the display during fill. Afterwards the estimat
-
ed end of cycle time is displayed.
•
H2O SUPPLY
Cannot sense water level (water supply possibly turned off).
•
LID
Cycle stopped because lid is open. Close the lid and press the Start
button if needed.
•
SENSING
Sensing out-of-balance condition, waterproof items, or load size and
type before and during fill (normal).
•
PAUSE
Cycle paused because the lid was opened during start up sequence
or the Start/Pause button was pressed. Press Start button again to
restart the cycle.
Cycle status lights
: Shows whether the washer is in the
Pre-wash, Delay, Fill, Soak, Wash,
Rinse
or
Spin
portion of the cycle.
B
C