Hagie STS12i Combo, Руководство пользователя

Страница: 212 / 276

SECTION 8 –
MAINTENANCE AND STORAGE
8-13
2. Remove Return Filter Housing cover and
set aside.
3. Remove and discard used Return Filter.
4. Install new Return Filter.
5. Reinstall filter housing cover and bolts.
Pressure Filter
1. Unlatch and lower metal shield (located
beneath front end of machine).
2. Using a 15/16” wrench on the Pressure
Filter Housing end bolt, turn “counter-
clockwise” and remove filter housing.
3. Remove and discard used Pressure Filter.
4. Install new Pressure Filter.
5. Reinstall Pressure Filter Housing and
metal shield.
Charge Pump Filter
1. Ensure the engine is shut OFF.
2. Hold the Charge Pump Filter (located
beneath the drive pump) in place and
remove filter from housing using a
24mm wrench.
3. Remove and discard used Charge Pump
Filter.
NOTE: Inspect the plug and seal surfaces in
the filter bracket. Replace any
damaged components.
Return Filter Housing
(Located on left-hand side of
machine near hydraulic oil reservoir)
-Typical View
Return Filter
(Located inside filter housing)
-Typical View
Pressure Filter Housing
(Located beneath right-hand side of
machine - lower metal shield to access)
-Typical View
Charge Pump Filter
(Located beneath drive pump)
-Typical View