Hagie STS12i Combo, Руководство пользователя, Страница: 162 / 276

SECTION 7 –
SPRAY SYSTEMS
7-29
The Solution Pump draws solution out of
the tank at the rate determined during
calibration. It dispenses solution through the
many valves and hoses that make up the
Spray System. The Solution Pump also
dispenses fluids through the Agitation and
Rinse Systems.
Refer to the Spray System Console
manufacturer’s operation manual for further
information on solution pump control.
Solution Pump Switch
The Solution Pump Switch (located on the
side console) is used to turn on/off the
Solution Pump.
NOTE: Leaving the Solution Pump Switch in
the ON position can cause the pump
to run continuously, which may result
in system damage.
• Press the Solution Pump Switch in the
UP position to turn ON (enable).
• Press the Solution Pump Switch in the
DOWN position to turn OFF (disable).
NOTE: When the Solution Pump is ON, a
Solution Pump Indicator (located on
the Machine Display Home Page -
Field Mode) will illuminate.
Flow Meter
The Flow Meter (located beneath the
right-hand side of machine) monitors the
solution flow and sends information back to
the Spray System Console.
NOTE: Flow Meter Calibration = 378
pulses/per gallon (standard volume
system).
Solution Pump and
Solution Pump Control Valve
(Located near center of machine)
-Typical View
* View shown from top of machine
• Solution
Pump
• Solution
Pump
Control
Valve
Solution Pump Switch
(Located on the side console)
-Typical View
Solution Pump Indicator
(Located on the Machine Display
Home Page - Field Mode)