SECTION 2 –
SAFETY AND PRECAUTIONS
2-2
ply may result in passenger falling off of
machine and/or obstructing the opera-
tor’s view.
•
Ensure there is adequate clearance before
driving under any overhead obstructions.
Contact with power lines may result in
serious injury or death.
•
Booms must be folded and in cradles
when driving the machine on a roadway
or when near power lines.
Keep Riders Off Machine
•
Do not permit passengers to ride on the
machine or in the cab. The only time a
passenger should be permitted to ride
inside the cab is for instructional or diag-
nostic purposes only. The passenger
should be seated in the Instructor Seat
next to the operator and never allowed to
ride outside of the cab.
Remove Paint Before Welding or
Heating
•
Avoid toxic fumes and dust. Hazardous
fumes can be generated when paint is
heated by welding, soldering, or using a
torch.
•
Do not use chlorinated solvents in areas
where welding will take place.
•
Perform all work in an area that is well
ventilated to carry toxic fumes and dust
away.
•
Dispose of paint and solvents properly.
Avoid Heating Near Pressurized
Lines
•
Avoid torching, welding, and soldering
near pressurized hydraulic lines. Pressur-
ized lines may accidentally burst when
heat goes beyond the immediate flame
area.
Handle Fuel Safely
•
Always turn the engine off and allow it to
cool before refueling.
•
NEVER smoke while refueling.
•
Do not fill tank completely, as fuel may
expand and run over.
•
Always clean up spilled fuel with soapy
water.
•
Keep a fire extinguisher nearby when
refueling.
Содержание STS12i Combo
Страница 276: ......
