Hagie STS12i Combo, Руководство пользователя

Страница: 187 / 276

7-54
SECTION 7 –
SPRAY SYSTEMS
NOTE: Refer to the Raven manufacturer’s
operation manual for information on
calibrating the Injection Pumps.
2. Turn desired Outlet Selector Valve
(located on the Injection Pump that you
are calibrating) in the TANK position.
This will allow the chemical to divert
back to the tank rather than the booms
during the calibration process.
NOTE: Outlet Selector Valves are
distinguished by a blue marking
located on the valve.
NOTE: Refer to the provided label (located
behind the Injection Pump access
door) for valve handle orientation.
See following illustration.
3. When pump calibration is complete, turn
Outlet Selector Valve in the BOOM posi-
tion to send chemical to the Mixer
Assembly.
Rinsing the Supply Lines and
Injection Pumps
If chemical remains in the tanks at the end
of the day, it is recommended to rinse
chemicals from the supply lines and injection
pumps. To accomplish this:
•
Turn the Inlet Selector Valves AWAY
from tank ports to activate the Injection
Pumps. (This will allow fresh water from
the rinse tank to flow through and flush
the lines and pumps).
NOTE: Refer to the provided label (located
near each Inlet Selector Valve) for
valve handle orientation.
• 60-gallon/227 L tank Inlet Selector Valves are
located on the outer side of each tank.
• 120-gallon/454 L tank Inlet Selector Valve is
located beneath Tank 2 on underside of
machine.
NOTE: If your machine is equipped with the Tall
Corn Package, you must first remove the
center panel beneath machine to access the
120-gallon/454 L tank Inlet Selector Valve.
Outlet Selector Valves
(Located on each Injection Pump)
-Typical View
Inlet Selector Valve - 60 Gal./227 L Tanks
(Located on the outer side of Tanks 1 and 3)
-Typical View