8-36
SECTION 8 –
MAINTENANCE AND STORAGE
cautions Section
for proper location of
warning decals and corresponding part
number.
NOTE: For decal replacement, contact the
Hagie Customer Support department.
12. Apply multi-purpose grease to coat
exposed hydraulic cylinder rods.
13. Refer to the Spray System Console man-
ufacturer’s operation manual for detailed
information on storage procedures for
the console and flow meters.
14. If the machine must be stored outside,
cover with a waterproof cover.
Winterization
To winterize the spray system, it is
recommended that you use an
environmentally safe type of antifreeze and
water mixture that will give you adequate
protection to -30 degrees F.
•
Drain any remaining solution in the
spray system.
•
Thoroughly rinse the spray system.
•
Run antifreeze/water mixture through the
spray system until it comes out all of the
boom openings.
•
Repeat process for both the Foam
Marker and Rinse Systems.
•
Refer to the Raven manufacturer’s opera-
tion manual for information on winteriz-
ing the 12i Chemical Injection System (if
equipped).
Removing From Storage
1. Inspect the condition of and test the air
pressure of all tires.
2. Carefully unseal all openings that were
previously sealed in the “Preparing for
Storage” process.
3. Clean and reinstall the batteries. Be sure
to attach the battery cables to the proper
terminals.
4. Tighten all belts. Inspect and replace any
worn belts.
5. Check the engine oil, hydraulic oil, and
engine coolant levels, and add if neces-
sary.
NOTE: A mixture of 50/50 water/antifreeze
will cool adequately in the summer,
as well as protect in winter.
6. Thoroughly clean the machine and it’s
attachments.
7. Perform all recommended services as
instructed elsewhere in this section.
8. Attach the spray boom and manually
cycle all of the hydraulic functions 2 or 3
times to thoroughly lubricate the compo-
nents. Test the NORAC® system and all
of it’s functions according to the manu-
facturer’s operation manual.
9. Reset date and time on Machine Display.
10. For starting instructions, refer to “Engine
- Starting” provided in the
Engine and
Drive Systems Section
elsewhere in this
manual.
NOTICE
Protective compounds such as grease
can harden under exposure to weather
conditions. Be sure to remove any dried
grease and reapply new, if necessary.
Содержание STS12i Combo
Страница 276: ......
