Grizzly G1023RL, Руководство пользователя

Страница: 71 / 96

Model G1023RL Series (Mfd. Since 12/11)
-69-
Fence Scale
Calibration
The fence scale indicator window, shown in
Figure 120, can be calibrated with the fence
scale if you notice that your cuts do not accurately
match what is shown on the fence scale.
Figure 120. Fence indicator window.
The indicator adjusts by loosening the two mount-
ing screws and sliding it in the desired direction.
Tools Needed Qty
Phillips Screwdriver ........................................... 1
Scrap Piece of Wood......................................... 1
To calibrate the fence scale indicator win-
dow:
1. Position and lock the fence at 13", as indi-
cated by the scale, cut your scrap piece of
wood.
2. Reposition and lock the fence at 12", as indi-
cated by the scale.
3. Flip your scrap piece of wood over, placing
the side that was cut in
Step 2 against the
fence, and cut your scrap piece of wood.
4. Measure the width of the freshly cut workpiece
with a tape measure. The workpiece width
should be exactly 12". If it is not, then adjust
the indicator window hairline to match the
width of the workpiece.
Screws
Miter Gauge
Adjustments
The miter gauge (see Figure 121) is equipped
with stop screws that allow you to easily adjust
the miter gauge from 45° to the left, 90°, and 45°
to the right. The stop screws contact a stop link,
which moves in or out of the way for adjustments.
Also, a pair of set screws can be adjusted so the
miter bar is snug in the T-slot.
Lock Knob
Stop Link
Pointer
Bar Adjustment
Set Screws
90º Stop Nut
90º Stop
90º Stop Screw
45º Stop
Figure 121. Miter gauge features.
Tools Needed Qty
90° Square ........................................................ 1
45° Square ........................................................ 1
Hex Wrench 2.5mm ........................................... 1
Hex Wrench 2mm .............................................. 1
Checking/Setting 90° Stops
1. DISCONNECT SAW FROM POWER!
2. Slide the miter gauge into the T-slot on the
table.
3. Loosen the miter gauge lock knob, raise the
stop link (see
Figure 121 above) all the way
up.
Hairline