Grizzly G1023RL, Руководство пользователя

Страница: 65 / 96

Model G1023RL Series (Mfd. Since 12/11)
-63-
11. Tighten one bolt a small amount and then
move on to each of the others, tightening
each down the same amount. Continue to
rotate through the bolts, tightening them a
little each time until they are all secure.
12. Now recheck the blade to miter slot at 90°
and 45° by repeating Steps 3-6.
—If the distance of A and B are equal,
continue to
Step 13, then go to Blade
Alignment.
—If the distances are still off, repeat this pro-
cedure until the distances are equal.
13. Once the miter slot is adjusted to the blade,
recheck all measurements and be sure the
table mounting bolts are secure. Also, if you
remove the table in the future, note the shim
placements and reassemble them exactly
how they came apart.
Blade Alignment
If the blade contacts the table insert when raised
or tilted, the blade must be aligned. The blade
can be adjusted by moving the table or trunnion
assembly. Try moving the table first, then, if addi-
tional adjustment is needed, move the trunnion
assembly.
Tools Needed Qty
Hex Wrench 8mm .............................................. 1
Wrench 14mm ................................................... 1
Adjusting Blade Alignment by Moving
Table
1. DISCONNECT SAW FROM POWER!
2. Loosen the four table mounting bolts (Page
62, Figure 106) and adjust the table until the
blade does not contact the insert. Tighten all
the mounting bolts.
3. Make sure the blade does not contact the
table insert when raised or tilted. Recheck
parallelism of the blade to the miter slot (refer
to
Page 61). Adjust as necessary until the
blade does not touch the insert.