Grizzly G1023RL, Руководство пользователя

Страница: 26 / 96

-24-
Model G1023RL Series (Mfd. Since 12/11)
To connect a dust collection hose:
1. Fit a 4" dust hose over the dust port, as
shown in Figure 27, and tightly secure in
place with a hose clamp.
Figure 27. Dust hose attached to dust port.
Insert the plug attached to the machine power
cord into a matching power supply receptacle.
The machine is now connected to the power
source.
If you need to disconnect the machine from power
later, pull the plug completely out of the recep-
tacle.
G1023RL/RLW/RLX/RLWX Power
Connection
Power Connection
Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the
POWER
SUPPLY section in this manual, and all previ-
ous setup instructions in this manual must be
complete to ensure that the machine has been
assembled and installed properly.
Dust Collection
Recommended CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
Components and Hardware Needed: Qty
Dust Hose 4 " (not included) ...............................1
Hose Clamps 4" (not included) ..........................2
DO NOT operate the table saw without an
adequate dust collection system. This saw
creates substantial amounts of wood dust
while operating. Failure to use a dust col-
lection system can result in short and long-
term respiratory illness.
2. Tug the hose to make sure it does not come
off.
Note: A tight fit is necessary for proper
performance.
Mounting Router
Guard & Router
Install the included router guard and a router (not
included) on the Model G1023RLW or Model
G1023RLWX now, using the instructions provided
with the router table extension. You MUST install
the router guard on a shop-made fence for all
router extension table operations to reduce the
risk of serious personal injury.
Scale & Cursor
Install the scale and cursor now on the Shop Fox
Classic Fence, using the instructions provided
with the fence.