Grizzly G1023RL, Руководство пользователя

Страница: 45 / 96

Model G1023RL Series (Mfd. Since 12/11)
-43-
Auxiliary Fence
The auxiliary fence is necessary if you are
resawing a workpiece that is more than 3" tall. It
should be no less than
1
⁄
2
" shorter than the board
to be resawn.
Components Needed for the Auxiliary Fence:
Wood*
3
⁄
4
" x (Height) x (Length of Fence) ..........1
* Only use furniture grade plywood, kiln dried hard-
wood, or or HDPE plastic to prevent warping.
Tools Needed for the Resaw Barrier:
Table Saw ..........................................................1
Jointer and Planer ....................... Recommended
Clamps ............................................... 2 Minimum
Drill and Drill Bits ................................................1
Wood Screws #8 x 2" .........................................6
To build the auxiliary fence:
1. Cut the auxiliary fence board to size as speci-
fied above. If you are using hardwood, cut
the board oversize, then joint and plane the
board to the correct size to make sure the
board is square and flat.
Note: Only use furniture grade plywood or
kiln dried hardwood to prevent warping.
2. Unthread the fence face mounting screws,
then remove the fence face from the fence
assembly.
3. Place the auxiliary fence next to the fence
face you removed in Step 2, mark the loca-
tion of the six mounting holes on the auxiliary
fence, then drill and countersink the holes in
the auxiliary fence.
4. Attach the fence face (removed in Step 2)
and the auxiliary fence to the fence body
with (6) #8 x 2" wood screws. The end result
should be similar to
Figure 63.
Figure 63. Auxiliary fence.
Fence
Body
Auxiliary
Fence
Fence
Facing
Resawing Operations
The table saw motor is pushed to its limits when
resawing. If the motor starts to bog down, slow
down your feed rate. Motor overloading and blade
wear can be reduced by using a ripping blade.
Ripping blades are designed to clear the sawdust
quickly.
Components Needed for Resawing:
Zero Clearance Insert .........................................1
Ripping Blade 10" ...............................................1
Clamps ...............................................................2
Shop Made Auxiliary Fence ...............................1
Shop Made Resaw Barrier .................................1
You may experience kickback during this
procedure. Stand to the side of the blade
and wear a full face shield to prevent injury
when resawing.
To perform resawing operations:
1. DISCONNECT SAW FROM POWER!
2. Remove the standard table insert and the
blade guard/spreader assembly.