GREAT PLAINS YP2425, Руководство оператора

Страница: 20 / 166

2016-11-16 Table of Contents Index 401-406M
YP2425 and YP2425F Table of Contents Index Preparation and Setup 16
Hitching with 3-Point
Refer to Figure 4
1. Connect your tractor 3-point to the planter 3-point
hitch. If using quick hitch be sure planter locks into
hitch securely.
2. Raise tractor 3-point just enough to relieve pressure
from parking stands.
3. Swing up and pin up 3-point stands. See “ Storing
3-Point Parking Stands ” on page 21.
Load Sway Risk:
Adjust 3-point hitch arms and sway blocks to minimize any
side-to-side sway to assure proper tracking in the field and
safe road travel.
4. Connect hydraulic hoses to tractor remotes. See
“
Hydraulic Hose Hookup ” on page 17.
5. Connect electrical cables. See “ Electrical Hookup ”
on page 20.
6. Remove and store main tongue parking stand. See
“
Store Main Parking Stand ” on page 20.
Hitching with Hydraulic Tongue (Option)
Refer to Figure 5
1. Move the tractor to near hitching position.
2. Connect the hydraulic hoses for the tongue circuit.
This needs to be done before hitching in order to
raise and lower the tongue. See “
Hydraulic Hose
Hookup ” on page 17. Allow slack for hitch
movements. Close the tongue cylinder bypass valve.
3. Make electrical connections for at least the planter
control circuit (necessary to control planter hydraulic
systems). See page 20.
4. Check that hitch local bypass valve is closed.
Refer to Figure 6
5. Set the cab Clutch Folding Module Lift/Hitch
switch
to Hitch.
6. Retract the Hitch/Lift circuit to set the tongue height
to clear the draw-bar. Back the tractor into alignment
and pin the draw-bar.
7. Connect safety chain to a suitable anchor point on
the tractor.
Figure 4
3-Point Hitching
21924
Figure 5
Hitching with Hydraulic Tongue
(Bypass Valve Closed)
28477
1
1
2