GREAT PLAINS 2S-2600, Руководство оператора

Страница: 41 / 114

2S-2600/F/HD/HDF Table of Contents Index Operating Instructions
Great Plains | 195-440M | 2019-05-03 Table of Contents Index 37
Loading Materials
The drill must be hitched for seed loading. Seed may be
loaded in the field or prior to transport.
Fully loaded with dense seed, the drill can weigh an
additional 5389 lbs (2444 kg). Include this weight when
checking tractor capability.
The mainframe may be raised or lowered. Lowered
places the walkboards closer to the ground, reducing
effort when manually loading bagged seed. If equipped
with ladders, swing them down.
Load slightly more material than needed, because
consumption rates can vary between compartments
even though the furrow rates are identical.
Do not overfill boxes. Contents should be level with the bottom
of the lid opening. Overfilling can damage boxes and hinge
supports.
Possible Agricultural Chemicals Hazards:
Take all necessary materials safety
precautions when loading dusty seed,
treated seed or fertilizer.
Loading Main Seed Box
1. Check that all meter doors are positioned for the
seed size, and not set for clean-out. See “ Position
Seed Cup Doors ” on page 49. If loading prior to
transport, set them to position 1 (smallest seed).
2. Install or remove optional seed plugs as desired for
the row spacing planned. See “ Seed Tube Plug
(Small Seeds) ” on page 93.
3. If loading prior to transport, and calibration has not
yet been done, set Seed Rate Handles to 0. At 0,
and with the doors at 1, no seed can leak during
transport.
4. On HDF (fertilizer-capable) drill models:
• Check that any offset box dividers are set to the
desired compartment ratio. See “ Offset Box
Divider ” on page 91.
• Check that the divider flap is set as desired
(separate compartments, or all-seed). See
“ Fertilizer Box Operation ” on page 40.
• If seeding only from the forward (seed)
compartment, flip the top spill flap back to
prevent seed from entering the fertilizer
compartment. See “ Fertilizer Box Operation ”
on page 40.
5. Take all necessary materials safety precautions if
the seed is treated.
6. Load seed into seed boxes. Make sure material is
loaded or spread evenly across all partitions. Use
tool or gloved hand. Do not over fill boxes.
7. To reduce wear, remove main shaft drive chains for
small seed boxes.
Loading Small Seeds Box
1. If loading prior to transport, and calibration has not
yet been done, set Seed Rate Handles to 0. At 0,
no seed can leak during transport.
2. Take all necessary materials safety precautions if
the seed is treated.
3. Load seed into seed boxes. Make sure material is
loaded or spread evenly across all partitions. Use
tool or gloved hand. Do not over fill boxes.
4. To reduce wear, remove main shaft drive chains for
main seed boxes.
Figure 31
Fill Decal
858-070C
Figure 32
Fill Decal on Bottom of Box Lid
68472