GRASS VALLEY K2 BASECAMP EXPRESS, Инструкция по установке и обслуживанию

Страница: 352 / 366

33. When a zone is created, its zone type is soft. For Zone3 and Zone4, change the zone type to a
hard zone as follows:
a) In the Zone Sets tree, right-click the zone and select
Set Zone Type
from the popup menu.
b) In the Set Zone Type dialog, open the Zone Type pull-down menu and select
ACL
, then click
the
OK
button.
c) Repeat steps for the other zone.
34. In the Port/Device tree on the right of the Edit Zoning dialog box, select ports
0 - 7
(Shift + Click)
and drag them into the
Zone3
.
35. Click the
Apply
button. In the Save Zoning & Error Check dialog, click
Save Zoning
, then
Yes
,
OK
, and
Close
to save changes to the zoning database.
36. In the Port/Device tree on the right of the Edit Zoning dialog box, select ports
8 - 15
(Shift +
Click) and drag them into the
Zone4
.
37. Click the
Apply
button. In the Save Zoning & Error Check dialog, click
Save Zoning
, then
Yes
,
OK
, and
Close
to save changes to the zoning database.
38. Close the Edit Zoning dialog box.
The Fibre Channel switch zoning procedure is complete.
Fibre Channel fabric cabling
Make your cable connections symmetrical when cabling a multiple switch fabric. For example, for
a K2 SAN-attached client system (or Server) that has redundant connections that each go to a
different switch, if you make one connection to port 1 on switch A, make the other connection to
port 1 on switch B. This is especially important on switches that are not interconnected by ISLs, as
the Fibre Channel failover path can get confused if redundant cable connections are not in the same
order on both switches.
The preceding procedure, "Fibre Channel switch zoning", applies to a system with four K2 Media
Servers, two 16 port Fibre Channel switches, and four K2 RAID storage chassis with redundant
controllers. To cable the Fibre Channel fabric for such a system, do the following:
• Each K2 Media Server is connected to a different zone. For example, connect as follows:
• Connect K2 Media Server 1 to switch A port 0 (Zone 1)
• Connect K2 Media Server 2 to switch A port 8 (Zone 2)
• Connect K2 Media Server 3 to switch B port 0 (Zone 3)
• Connect K2 Media Server 4 to switch B port 8 (Zone 4)
There is only one Fibre Channel connection at each K2 Media Server. The second Fibre Channel
port on each K2 Media Server not used.
352 K2 SAN Installation and Service Manual 02 February 2012
Custom K2 SAN systems