GRASS VALLEY K2 BASECAMP EXPRESS, Инструкция по установке и обслуживанию

Страница: 160 / 366

2. Click
Launch Storage Manager
.
Storage Utility opens.
3. Leave the Configure K2 Server wizard open while you use Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Next, use Storage Utility to configure the RAID storage and file system.
Configuring RAID
Use Storage Utility to complete the configuration of the K2 RAID storage devices, as explained in
the following topics.
Configuring RAID network and SNMP settings
Prerequisites for the K2 RAID chassis are as follows:
• Fibre Channel cable(s) connected
• Ethernet cable(s) connected
• Power on
Prerequisites for the optional K2 RAID Expansion chassis (if present) are as follows:
• Fibre channel cable(s) connected
• Power on
Use the Storage Utility to configure the following settings for the K2 RAID controller:
• IP address
• Subnet mask
• Gateway Address
• SNMP trap destinations
For K2 RAID, network and SNMP settings are set and stored on the RAID controller module. For
the RAID chassis with two controllers, each controller has its own network settings and the RAID
chassis exists as two entities on the control network.
The RAID storage device is configured by default for the SNMP community name “public”. If your
site’s policies require using a different SNMP community name, contact your Grass Valley
representative.
1. Launch Storage Utility from the K2Config application.
2. As prompted, wait while Storage Utility gathers system information, then Storage Utility opens.
160 K2 SAN Installation and Service Manual 02 February 2012
Configuring and licensing the K2 SAN