Close and re-open the sequence to reset the Story view.
Workaround:
Attempting to do a voice over conform causes the Conform
Server to hang up or an error message to appear on the
Conform Server.
Description:
CR111054
A vbrNasDriveMap utility needs to be run so that the conform
service will see the Z: drive mapping.
Workaround:
Aurora Edit models SDFX/HDFX
Aurora Edit fails to start if the input signal is corrupt.
Description:
CR77369
Verify all cables are terminated if using a split signal.
Workaround:
A limitation in the SDFX/HDFX I/O card generates a bad
signal in the VGA when using a 1080i source with 720p video
settings. You are able to record this bad signal and use it.
Description:
CR81517
Verify that video settings in Aurora Edit are correctly set to
1080i.
Workaround:
Play to tape inconsistent with mark IN points.
Description:
CR82354
None
Workaround:
HDSDI output from HDFX to a Sony HDXDCAM deck with
fi
rmware 1.62 there is no audio.
Description:
CR82652
None
Workaround:
Aurora Edit may not launch if running under a non
Administrator account.
Description:
CR83022
Modify the registry
fi
le HKEY_LOCAL_MACHINE | System
| CurrentControlSet00X | Enum. Then apply Read permission
Workaround:
to Everyone to the Enum key under CurrentControlSet00X.
Make the registry change as an administrator and then log in
as the non-admin and it should work
fi
ne.
Aurora Edit models SDR/HDR output
Negative varispeed video displays
fi
eld swapping on the external monitor during play
preview.
Playback of some effects, such as blur, may be choppy.
Description:
CR71317
Rendering the blur will alleviate the choppy playback.
Workaround:
Aurora stream
After adding a new Aurora Edit system to a K2 network, the
Self-Test fails with the error,
“
Stream Count Not Set
”
, even
though the bandwidth setting from the K2 server is correct.
Description:
CR94561
76
Aurora Edit and Edit LD Version 7.1.0 Release Notes and Upgrade Instructions
18 October 2010
Known Issues
