4. Press
F10
to accept.
5. Select
File | Save changes
and press
Enter
.
6. Press
F10
to accept. The system will restart.
•
Aurora Edit SDFX/HDFX models
•
If you are installing Aurora Edit SDFX/HDFX on an HP xw9300, you must
make the following BIOS change for proper cooling. Failure to do so may result
in overheating, which can cause unpredictable behavior and possibly hardware
failure.
1. Turn on the xw9300 and press
F10
to enter the BIOS setup.
2. Select
Advanced | Thermal
and press Enter.
3. Select
Full Speed Chassis Fans
, and change it from Disable to
Enable
.
4. Press
F10
to accept.
5. Select
File | Save changes
and press Enter.
6. Press
F10
to accept. The system will restart.
•
If you are installing Aurora Edit SDFX/HDFX on an HP xw8400, you must
make the following BIOS change for proper cooling. Failure to do so may result
in overheating, which can cause unpredictable behavior and possibly hardware
failure.
1. Turn on the xw8400 and press F10 to enter the BIOS setup.
2. Select
Power | Thermal
and press Enter.
3. Select
Fan Idle Mode
, and change it from 1 bar (minimum) to
7 bars
(maximum).
4. Press
F10
to accept.
5. Select
File | Save changes
and press Enter.
6. Press
F10
to accept. The system will restart.
Hyper Threading
Hyper Threading should be disabled for Intel processors that support this feature. This
is typically controlled via the system BIOS. Performance tests with Aurora Edit have
consistently demonstrated a decrease in overall performance when Hyper Threading
is enabled.
Microphone Recording
When you record to Timeline using a microphone source, the
fi
rst few frames of the
sound recording incorrectly includes sound from the Timeline. This is because
Windows, by default, feeds the sound card output back into the input.
To change the Windows setting and correct this problem:
1. Go to
Start | Settings | Control Panel | Sounds and Audio Devices
.
2. b. Click on the
Audio
tab.
3. Under Sound recording, click on
Volume
.
4. On the Recording Control dialog, select
Mute
for the Stereo Mix source.
72
Aurora Edit and Edit LD Version 7.1.0 Release Notes and Upgrade Instructions
18 October 2010
Operation considerations
