GRAPHTEC CS610-11eN, Руководство по обслуживанию

Страница: 89 / 132

CS610-UM-251-9370 9-3
9. BOARDS AND ELECTRICAL COMPONENTS
9.3 Replacing the Ethernet Board
(1) After replacing the ethernet board, you need to input the MAC address to the ethernet board.
(2) Use Scanning Master 21+ to input the MAC address.
Input the MAC address to the ethernet board
(1) Use the USB cable to connect the CS610 and PC.
(2) Turn on the power for your PC and start OPS112.
(3) When OPS112 starts, follow the steps given below to input the MAC address.
1. Access the "Help" menu and select "About." At this time, a dialog box will appear.
2. Point to the icon in the window and click while pressing and holding down the "Ctrl" key.
3. Click the "OK" button while pressing and holding down the "Shift" key. This makes the status
available for adjustment.
4. Select "Setup ID" from the "Adjust" menu to display the Adjust Scanner window.
5. The following dialog box appears. Input the 10-digit MAC address shown on the data controller
board
.
6. Click the "Set" button to register the MAC address.
7. Click the "Close" button to end the adjustment mode.