GRAPHTEC CS610-11eN, Руководство по обслуживанию

Страница: 13 / 132

CS610-UM-251-9370 2-3
2. PART NAMES AND FUNCTIONS
POWER LED
Not lit : Power is turned off.
Lit green : The power is on and the scanner is operating in normal mode.
Flashing orange : The scanner is in power-saving mode.
PAPER LED
Not lit : Normal mode.
Lit green : The scanner is ready to scan.
Flashing green : The scanner is currently scanning a document (reading image data) or
an abnormality in raising/lowering the top cover is detected.
ERROR LED
Not lit : Normal mode (no errors)
Lit red : Hardware error.
Flashing red : The LED flashes red when a document is detected in the scanner
during the power-on selftest, when the STOP button is pressed during
scanning, when a paper jam is detected, when the document length
is shorter than the scan length,
*1
or when an abnormality in raising/
lowering the top cover is detected.
*1 If the driver software has been set to check end-of-paper processing.
ITA button
Switch between ITA (thickness-detection) and READY (normal) modes.
READY LED
Lit green : READY mode.
Not lit : ITA mode.
ITA LED
Not lit : READY mode.
Lit green : ITA mode.
Flashing green : The scanner is operating in ITA mode.
LED
Mode
READY LED ITA LED
READY mode Lit green Not lit
ITA mode Not lit Lit green
Safety mode* Not lit Not lit
*When something is blocking the scanner.
SCAN button
If the scanner is connected to a computer, it scans the current document in accordance
with the parameters set by the Scanning Master 21+ software. If the software is not
active, it is started in order to receive the data from the scanner.
*2
*2 This button works during READY mode, but has no effect during ITA mode.
FORWARD button
• During READY mode
Moves a document into position. If this button is pressed while the scanner is in READY
mode, READY mode is cleared and the document is ejected to the rear of the scanner.
• During ITA mode
If a thick document has been placed in the front paper sensor section of the scanner at
the time this button is pressed, the thickness-detection process will begin automatically.
Control panel
POWER
P
READY
ITA
APER
ERROR
SCAN
FORWARD
REVERSE
STOP
ITA