310531
5
WARNING
FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition and
result in fire or explosion and serious injury.
Ground the equipment and the object being sprayed. The PrecisionFlo metering valve is grounded
through proper connection of the two electrical cables. See Ground the Control Assembly on
page 13.
If there is any static sparking or you feel an electric shock while using the equipment, stop dis-
pensing immediately. Do not use the equipment until you have identified and corrected the
problem.
Make sure all electrical work is performed by a qualified electrician only.
Have any checks, installation, or service to electrical equipment performed by a qualified electrician
only.
Make sure all electrical equipment is installed and operated in compliance with applicable codes.
Do not install the PrecisionFlo module in a hazardous area, as defined in Article 500 of the National
Electrical Code (USA).
Make sure power is disconnected when servicing and repairing equipment.
Keep the dispensing area free of debris, including solvent, rags, and gasoline.
Before operating the equipment, extinguish all open flames or pilot lights in the dispense area.
Do not smoke in the dispensing area.
Disconnect the two electrical cables from the PrecisionFlo metering valve before servicing the
valve.
Keep liquids away from the electrical components
Turn off power to the PrecisionFlo module before disconnecting any cables connected to the con-
trol assembly or fluid metering assembly.
Disconnect electrical power at the main switch before servicing the equipment.