Connect
Connect
Connect the
the
the Fluid
Fluid
Fluid Hose
Hose
Hose from
from
from the
the
the Gun
Gun
Gun to
to
to the
the
the Cabinet
Cabinet
Cabinet
1.
Blow the waterborne fluid hose out with air and
flush with flushing fluid to remove contaminants.
2.
Connect the Graco waterborne fluid hose to the
gun as described in the spray gun manual. See
the spray gun manual for hose information and
dimensions.
3.
Before entering the cabinet:
a.
Follow the
.
b.
Follow the
Pressure Relief Procedure, page 30
.
c.
Open the cabinet. Slide the electrostatic
shield (82) up to remove, and then slide the
electrostatic shield (12) to the left to remove.
4.
Loosen the strain relief nut at the hose inlet end
(101c).
5.
Slide the other end of the hose through the hole in
the side of the isolated enclosure (CA). Connect
the swivel (101h) to the fluid outlet of the pump.
6.
Secure the hose to the side of the enclosure
with the bracket (101j). A bolt (S) assembles
through the hole in the bracket and screws into
the side of the enclosure. Set screw (101m) can
be loosened to rotate the bracket if needed.
7.
Tighten the strain relief nut (101c) and set screw
(101m).
Figure 8 Hose Connection at Enclosure
Figure 9 Hose Connection at Enclosure
18
3A8492A
Содержание HydroShield WABH00
Страница 139: ...Notes Notes Notes Notes 3A8492A 139...
