Graco HydroShield WABH00, Инструкция - Каталог запасных частей

Страница: 130 / 142

Repair Kits and Accessories
Color Color Color Change Change Change Module Module Module Configuration Configuration Configuration
Configure each module according to its designated
number, as follows:
NOTICE NOTICE
NOTICE
To avoid damaging the circuit boards, wear Part
No. 112190 grounding strap on your wrist and
ground appropriately.
To avoid electrical component damage, remove all
system power before plugging any connectors.
1. Prepare the electrical controls for service. Follow
the steps in
Prepare the Electrical Controls for
Service, page 106 .
2. Disconnect electrical power from the system.
3. Open the color change module. Locate switches
S4, S5, and S6 on the control module board. The
switches are shipped in the OFF position.
4. For each module, set the switches to ON or OFF,
as shown in the following table.
Non Non Non---IS IS IS Control Control Control Module Module Module Switch Switch Switch Settings Settings Settings
Control Control
Control
Module
Module
Module
S6 S6
S6
S5 S5
S5
S4 S4
S4
Electronic
Controls
OFF
ON
OFF
ON
OFF
ON
Color
Change
OFF
ON
OFF
ON
OFF
ON
Replace Replace Replace the the the Color Color Color Change Change Change Board Board Board
NOTICE NOTICE
NOTICE
To avoid damaging the circuit boards, wear Part
No. 112190 grounding strap on your wrist and
ground appropriately.
To avoid electrical component damage, remove all
system power before plugging any connectors.
1. Prepare the electrical controls for service. Follow
the steps in
Prepare the Electrical Controls for
Service, page 106 .
2. Disconnect electrical power from the system.
3. Remove the color change module cover (704).
4. Note where each cable is connected, then
disconnect all cables from the color change
board connectors.
5. Remove the seven mounting screws (703) and
the board (702).
6. Install the new board. Reinstall the screws.
7. Reconnect the cables to the proper connectors,
as noted in step 3.
8. Reinstall the cover (704). Restore electrical
power to the system.
130 3A8492A