Graco HydroShield WABH00, Инструкция - Каталог запасных частей

Страница: 35 / 142

Operation
Adjust Adjust Adjust the the the Gun Gun Gun Fluid Fluid Fluid Settings Settings Settings
Preset 0 allows operators to change the gun fluid
pressure at any time. Preset 0 assumes a manual
purge profile.
Use Preset 1 through 99 to configure different
gun fluid pressure settings and a purge profile
number. To set up a purge profile, see
Purge Screens 1–5, page 53 .
For example, Preset 1 might use the best pressure
settings for black paint, Preset 02 might use the best
pressure settings for red paint, and Preset 99 might
be set to a higher fluid pressure to perform a quicker
flush.
For instructions on creating presets, see
Presets, page 52 . Refer to the gun setup procedure
in your gun manual to select the best gun fluid
settings.
To To To use use use Preset Preset Preset 0 0 0
Preset 0 can be changed by the operator at any time
during operation.
1. Press the right arrow until Home appears
on the menu bar.
2. Press the Enter Screen button to enter the
screen to edit the current settings.
3. Use the down arrow to navigate to the Fluid
field.
4. Press the numbers on the keypad to the desired
psi value.
5. Press the Enter button to register the value.
The interface automatically advances to the
Preset field.
6. Press the Exit Screen button to exit the
screen settings.
Note
If an operator is in Preset 1–99, and then
switches to Preset 0, Preset 0 will reflect the
previous settings.
To To To use use use Preset Preset Preset 1 1 1 through through through 99: 99: 99:
1. Press the right arrow until Home appears
on the menu bar.
2. Press the Enter Screen button to enter the
screen to edit the current settings.
3. Use the up and down arrows to navigate
to the Preset field.
4. Enter the Preset number that you would like to
use.
5. Press the Enter button to register the value.
6. Press the Exit Screen button .
Shutdown Shutdown Shutdown
1. Discharge the system voltage. Follow the
Fluid Voltage Discharge and Grounding
Procedure, page 29
.
2. Flush the gun. See Flush the System
(Systems without Color Change), page 31 or
Flush the System (Color Change Enabled
Systems), page 32
.
3. Follow the Pressure Relief Procedure, page 30 .
4. Press the Stop button on the control
interface to change to Off mode.
3A8492A 35