13
SERVO CONTROL screen
DRIVE ENABLE #3
This button when pressed will enable the servo drive.
RUN SETUP PROGRAM button #4
When this button is selected a factory preinstalled setup program will upload into the CTC Parker
Automation memory. Included in this setup program are various setup parameters that were previously
installed by the factory or by the operator.
RUN MAIN PROGRAM button #5
When this button is selected a factory-preinstalled program will upload into the CTC Parker Automation
memory. This program will give the machine the various instructions to perform the actual operations.
SERVO POWER ON button #1 and #2
This button connects electrical power to the machines’ servomotor material pump.
SERVO POWER OFF button #1 and #2
This button disconnects electrical power to the machines’ servomotor material pump.
DRIVE ENABLE ON/OFF button #3
This button enables/disables the machines’ servomotor to drive the material pump.
HOME Button
The pumps will immediately move to the home limit switch and remain in the home position. This position
is used when the machine ready to dispense material.
RESET SERVO button
This button will reset the machines’ servomotor to drive the material pump.
