40
Gossen Metrawatt GmbH
4.8
Sequence Operation (List)
The operating procedures for enabling/disabling sequence (list) operation are shown below:
1
Press the
key +
the key to enter into sequence (list) operation menu.
2
Use Entry keys or the knob to select list number (No.), and press the
Enter
key to confirm.
3
Use the
key to quit the sequence operation menu.
4
Use the
and
keys to activate the sequence (list) operation.
5
Use the
and
keys to stop the sequence (list) operation.
The operating procedures for setting the sequence (list) parameters are shown below:
1
Press the
key + the
key to enter into sequence (list) operation menu.
2
Use the Entry keys or the knob to select list number (No.), and press the
Enter
key to confirm.
3
Use the
▼
key to select list memo (Memo).
4
Use knob and the
◄
►
keys to edit memo (max. 10 characters).
5
Use the
▼
key to select sequence data (Data:<New/Edit>).
6
Use
◄
►
keys or knob to select New or Edit operation, and press the
Enter
key to confirm.
7
Use
◄
►
to select parameters.
8
Use Entry keys or use the knob together with
◄
►
keys to input set value; or use the knob/ key to select one operating mode, and
press the
Enter
key to confirm. After setting the third parameter, press the
Enter
key to confirm and enter into the next step.
9
If it is needed to modify one step, use
▲
and
▼
keys to select this step. The setting operations for this step are the same as
decribed under item 8.
10
If it is needed to add one step to the last step, use the
▼
key to select the new step. The setting operations for this new step are the
same as decribed under item 9.
11
If it is needed to insert one step above an edited step, use
▲
and
▼
keys to select this edited step. The LCD display doesn‘t flash
at this time, and press
key +
key to insert a new step.
The setting operations for this new step are the same as described under item 8.
12
If it is needed to delete an edited step, use the
▲
and
▼
keys to select this step. The LCD display will stop flashing, and press the
key +
key to delete. If there is only one step exists, it will exit the step edit screen.
13
Press the
key to exit step edit screen, and save the sequence data in EEPROM assigned by the sequence number.
14
Use the
▼
key to select the cycle times (Count); use Entry keys or the knob together with
◄
►
keys to input set value. Press the
Enter
key to confirm and save the cycle times (Count) in EEPROM assigned by the sequence number.
15
Use the
▼
key to select “Chain”; use Entry keys (the “Chain” is OFF when the Entry key exceeds 6) or the knob to input the set
value. Press the
Enter
key to confirm.
16
Press the
key to exit sequence operation menu.
17
Press the
key +
key to activate sequence operation.
18
Press the
key +
key to stop sequence operation.
