GLP KNV Dot, Быстрый старт и руководство по безопасности

Страница: 46 / 65

www.glp.de
46 KNV Dot and Line Quick Start and Safety Manual Rev. A
See Figure 30. Fasten the rigging clamp to the PSU’s mounting plate by passing the
M10 bolt or screw through the rigging clamp and tightening it into the M10 hole
D in
the mounting plate. The bolt must thread fully into hole D but it must not touch the
PSU’s housing.
Lift the complete assembly up to the rigging truss and fasten the rigging clamp to
the truss.
If there is a risk of injury or damage if the PSU falls, secure it with an approved safety
cable passed through one of the holes
E in the mounting plate (or through one of
the PSU’s handles) and then looped around a secure anchoring point. Take up as
much slack as possible in the safety cable before you fasten it.
5. Mounting on a truss using custom rigging hardware
To mount a KNV PSU on a rigging truss using custom brackets or other suitable rigging
hardware:
Obtain suitable hardware and rigging clamps. All hardware and clamps must be
approved for the weight that they will support. Check that all custom hardware
used is suitable for its purpose and strong enough to safely support the loads
applied to it.
See Figure 31 on page 47. Bolt mounting hardware to the M6 threaded holes
(arrowed) in the PSU’s handles using high-tensile M6 bolts. The bolts must thread fully
into the handles but they must not touch the PSU’s housing.
Fasten the PSU to a secure structure such as a rigging truss using high-tensile
fasteners and hardware that is approved for the weight that it will support.
If there is a risk of injury or damage if the PSU falls, secure it with an approved safety
cable passed through one of the holes (
E in Figure 28) in the mounting plate or
Figure 30. KNV PSU M10 threaded hole
D
E
E