GLP KNV Dot, Быстрый старт и руководство по безопасности

Страница: 25 / 65

German Light Products®
KNV Dot and Line Quick Start and Safety Manual Rev. A 25
Flying a column of KNV Dots using a KNV Dot Bracket
Warning!
You can install up to a maximum of five (5) KNV Dots in total hanging
vertically from a KNV Dot Bracket in one single, independently supported
column.
A column of KNV Dot fixtures that are joined together using GLP Slide
Connectors and suspended vertically is considered to be one unit. The top
KNV Dot must be secured by a safety cable that is approved for the total
load that it secures.
Any sideways movement at the bottom of a column of KNV Dots can cause
Slide Connectors or rigging hardware to fail because of the leverage
involved. Make sure that no lateral force can be applied to the bottom of a
column of KNV Dots by immobilizing it: fasten the bottom of the column to
secure anchoring points. Do not add to the load on rigging hardware by
applying downwards tension to the column when immobilizing it.
To create a single column of KNV Dots
suspended from a rigging truss using a KNV
Dot Mounting Bracket:
See Figure 13. Obtain either:
-
a KNV Rigging Clamp 13-55/45/15 and
5/8” Spigot, or
-
a Half-Coupler Clamp that is approved
for the total load that it will support.
Obtain an approved safety cable.
Fasten the KNV Dot Bracket to the
Rigging Clamp and Spigot or Half-
Coupler Clamp using a screw that is
approved for the load that it will support.
Fasten the first KNV Dot into the KNV Dot
Bracket.
Fasten the Dot, Bracket and Rigging
Clamp assembly to the truss.
If there is any risk that the KNV Dot will
cause injury or damage if it falls, secure it
with an approved safety cable as
described in ‘Securing with a safety
cable’ on page 19.
KNV Dot
Half-coupler
Clamp
KNV Dot
Bracket
Rigging
Clamp
13-55/45/15
5/8” (16 mm)
Spigot incl.
screw
Figure 13. Single column of 5 x KNV Dots
suspended using a KNV Dot Bracket
GLP Slide
Connector