GLP KNV Dot, Быстрый старт и руководство по безопасности

Страница: 23 / 65

German Light Products®
KNV Dot and Line Quick Start and Safety Manual Rev. A 23
Flying a single KNV Dot using a KNV Dot Bracket
To fly a single KNV Dot from a rigging
truss using a KNV Dot Bracket, see Figure
11:
Either:
-
fasten a 5/8” KNV Spigot into a KNV
Rigging Clamp 13-55/45/15, or
-
obtain a Half-Coupler Clamp that is
approved for the load that it will
support.
Fasten a KNV Dot into the KNV Dot
Bracket.
Fasten the KNV Dot and bracket to
the Rigging Clamp spigot or Half-
Coupler Clamp using the screw
supplied with the Rigging Clamp.
Fasten this assembly to the truss.
If there is any risk that the KNV Dot
will cause injury or damage if it falls,
secure it with an approved safety
cable as described in ‘Securing with
a safety cable’ on page 19.
Figure 11. Flying a single KNV Dot
using a KNV Dot Bracket
Rigging
Clamp
13-55/45/15
Half-coupler
Clamp
KNV Dot
Bracket
5/8” (16 mm)
Spigot incl.
screw
KNV Dot
B
Figure 10. Fastening KNV Dots to each other using a GLP Slide Connector
D
A
C