Gerber Dimension 200, Руководство пользователя

Страница: 75 / 111

System Preparation and Use 75
Table Mats
The
Dimension 200
table mats provide accurate depth control and
minimize the need for sacrificial material. They are installed at
the factory but are milled on-site after installation to provide a
perfectly flat surface.
A grid that aids alignment can also be engraved into the mats.
Files containing data for both operations are supplied with ART
Path, and bits for both operations are supplied in the tool kit.
Note: Gerber recommends using the Chip Removal System and pressure
foot for this procedure.
MAT MILLING
The mat milling data is supplied with ART Path in the file
D200MILL.RTP
.
1. In ART Path, choose Open from the File menu.
2. Highlight Router Files under List Files of Type to open
D200MILL.RTP
. Click on OK.
3. In the Setup menu, select Start/End position.
4. Set the Start/End position to start and end the machine at the
lower left.
5. Click on OK.
6. Install the table surfacing bit supplied in the tool kit.
7. On the ARC station, press Z INIT once to unlock the Z axis.
8. Place the tool height gage on the surface of the mats under the
bit. Use the Z axis knob to lower the tool until it just touches
the gage.
9. Press Z INIT once. This lifts the Z axis once and locks it. The
tool is now initialized to the table surface.