Gerber Dimension 200, Руководство пользователя

Страница: 48 / 111

48
Dimension 200
Resume Processing
After pausing temporarily, press the START key to resume
processing without position or data loss.
Change Tools
If a tool change is required, follow the steps below:
1. In STOP JOB mode, slew the carriage to a safe tool change
position.
Note: If a tool is changed during a job, the system remembers the
tool position and returns from slew to the appropriate location.
2. Turn OFF the router motor and disconnect the router motor
power cable from the router motor.
3. Change the tool. (See the sections on “Tool Installation” and
“Tool Replacement” in this manual, if necessary.)
4. Initialize the Z axis. (If needed, see the Z INIT function key
explanation in this section of the manual.)
5. Change the Feed Rate parameter, if necessary.
6. Reconnect the router motor power cable and turn ON the
router motor.
7. To avoid hitting clamps, manually slew close to where the job
will resume.
8. Reset the vacuum shroud (lower it back to the material
surface).
9. Press the START/STOP key to continue the job. The carriage
will return to the pause position, then enter STOP JOB mode.
Press START/STOP again to resume the job.