Gerber Dimension 200, Руководство пользователя

Страница: 29 / 111

Optional Equipment Installation 29
9. Attach the two tie mounts on top of the carriage (as shown in
the illustration on the previous page) and secure the hose.
10. Use the tie wraps to secure the hose to the cable harness in the
cable trough. Place a tie wrap about every 8" along the cable.
Tie the wraps firmly but not so tightly that coolant flow is
restricted.
11. Insert the barb fitting on the air line intake and connect the air
line.
12. Insert the quick-disconnect fitting to the opposite end of the
air line and connect to the compressor.
13. Turn on the Dimension 200. Make sure the coolant hose
travels smoothly in the cable trough by slewing the carriage
from one end of the beam to the other. The coolant hose must
not stretch as the carriage moves.
T-Vac Vacuum System
The optional T-Vac Vacuum System uses vacuum to hold down a
workpiece easily and securely on the router table. Depending on
the material and the job, vacuum hold-down may be used with
adhesive and sacrificial material.
T-Vac requires a vacuum blower, filter, and relief valve purchased
separately. The blower, filter, and relief valve must be connected
to the router table. Hose and necessary attachment fittings are
supplied with the router table.
To install the T-Vac Vacuum System
1. Place the filter directly below the intake opening at the rear of
the router table.
2. Position the blower as close to the filter as possible.