GEOSATpro DVR1100c, Руководство пользователя и инструкция по эксплуатации

Страница: 47 / 60

www.geosatpro.com Toll Free 888-483-4673
45
Connect the coaxial cable from LNBF #1 on
the dish antenna to the SAT IN port on the back of
the satellite receiver.
6.
Press
OK
to display the Signal Strength and Signal Quality meter
with Signal Quality Tone Beeper on the connected television.
7.
The receiver will automatically tune to channel 106, 3ABN English.
3ABN is the strongest and easiest channel to locate the satellite). A
low beeping sound will be emitted from the TV speakers. Press the
Blue Button on the remote to toggle ON/OFF the beeping sound.
This screen shot shows a receiver
that is not connected to a LNBF.
The meters show that there is no
Signal Level (
S
) or Signal Quality
( Q ) readings. Check to make sure
that a coax cable is attached from
the SAT IN port on the rear of the
satellite receiver to the LNBF #1
on the satellite dish.
A Signal Level reading of 50% or
better indicates that the receiver
is connected to a working LNBF.
Signal Quality readings below
10% indicate that the dish is not
properly aimed or the LNBF
properly rotated to receive the
satellite signal.
DO NOT connect the 22KHz
switch at this time!