GEOSATpro DVR1100c, Руководство пользователя и инструкция по эксплуатации

Страница: 54 / 60

B. Gohl
© Satelliteav.com
52
Inexpensive satellite meters can speed
up the installation process, but they only
display the signal strength of a satellite.
It is important to understand that signal
strength satellite meters do not indicate if
Install Procedure with a Signal Identification Meter
Connect LNBF # 1 (right side) to the meter and use data for
standard LNB type LO 10750, KU, AMC4, Horizontal and Vertical
transponders. Peak for maximum Signal Quality for AMC4.
Connect LNBF #2 (left side) and use a data set for standard
LNB type LO 10750, KU, Galaxy19, Horizontal and Vertical
transponders. Peak for maximum Signal Quality for Galaxy19.
Verify and balance the aiming for optimum AMC4 and Galaxy19
reception.
Note: Birdog meters may have difficulty detecting weaker FSS type
signals and must have the BER setting changed. Enter the main set-
up menu and change the BER setting to LOG (logarithmic).
Installer Tip
If you are having trouble locating the satellites, remove both LNBFs
from the clamp and install a DirecTV LNBF into the LNBF #1 (right
side) position. Locate the DirecTV 101w satellite with your meter
or a DirecTV receiver. Replace the Glorystar LNBFs into the clamp.
The Dish is now roughly aimed and will only require fine tuning for
optimal reception of the linear satellites.
•
•
•
Using Satellite Meters
the dish is aimed at the correct satellite and they will not be useful
for fine tuning the dish aiming or LNBF skew (rotation or tilt) for
maximum Signal Quality. Signal strength meters must be used along
with the satellite receiver to determine if the dish is aimed at the
correct satellite.
A digital identification meter such as a SatHawk, BirDog or SatBuddy
will simplify the installation process. Please consult with the owners
manual for correct operation.