GEOSATpro DVR1100c, Руководство пользователя и инструкция по эксплуатации

Страница: 49 / 60

www.geosatpro.com Toll Free 888-483-4673
47
Once the correct satellite is located,
make small adjustments in elevation
and azimuth until maximum signal
is indicated on the quality bar.
Signal Quality readings should be
50% or better to insure optimum
picture and sound on the receiver.
The higher the quality, the better
the reception. If the Signal Quality
Press the CH/DOWN arrow button on the remote control to place
the receiver on TBN, Channel 101. This is a strong channel on the
2nd satellite, Galaxy19 on LNBF #2.
Congratulations! The 1st satellite, AMC4 on LNBF #1 is now tuned
and the next few steps will optimize your installation for reception
of all Christian channels on the 2nd satellite Galaxy19.
Verify the Signal Quality reading is
at least 50%. If the Signal Quality
is less than 50%, make very small
adjustments to fine tune the dish
elevation and azimuth (side to
side).
Disconnect the coax cable from
LNBF #1 and connect to LNBF #2.
reading is low, the picture will break up into little squares and the
sound will become garbled, out of sync, choppy or will disappear
completely!