GEOSATpro DVR1100c, Руководство пользователя и инструкция по эксплуатации

Страница: 48 / 60

B. Gohl
© Satelliteav.com
46
While observing the Signal Quality (
Q
) reading, slowly move the
dish towards the right. Reference the distant landmark or the string
on the ground that you identified in your site check that corresponds
with the Azimuth (compass) reading. Usually the satellite will be
found within a few degrees either side of the compass reading.
If the dish is moved beyond 15 degrees from the site’s compass
reading and no Signal Quality is detected, sweep 15 degrees in the
opposite direction. When the correct satellite is found the beeping
sound changes to a higher tone, the Signal Quality bar turns Green
and the Spectrum Graph displays changes in Signal Quality.
The Signal Quality readings will increase as the correct satellite is
detected and fine tuned. If the dish is aimed at an incorrect satellite,
the Quality reading will display a low reading and not turn Green.
Locate and Peak Satellite Signal
The Signal Level (S) is not important in detecting the satellite.
Signal Level readings indicate a connection to a functioning
LNBF, not the detection of the correct satellite.
If no Signal Quality is detected,
increase or decrease the elevation
by one degree and repeat the slow
sweep. The elevation may need to
be ad/- 5 degrees depending
on the post being plumb. Move
the dish very slowly to allow the
receiver to process the signal
information and update the meter.
A movement of just 1/16th of a inch can result in a perfect or no
signal. This process may need to be repeated many times to aim and
peak the quality of the signal.
When the dish is correctly aimed the programming will display
and the Signal Quality reading will display a 50% or better level. A
stable signal on the Spectrum Graph with minimal ripple indicates
that the signal is optimized.