Gehl PowerBox 1639, Руководство оператора

Страница: 51 / 66

NOTE:
Tracks are NOT adjusted if Engine is
NOT running.
CHECK ENGINE COMPRESSION
Refer to OEM Engine manual.
NOTE:
Only an authorized OEM Engine dealer
can perform WARRANTY Service on the Engine.
CHECK REPLACE SPARK PLUGS
(1639 Gas)
Check periodically. Refer to OEM Engine Manual for
replacement procedure.
LUBRICATE 2000 HOUR
GREASE POINTS
NOTE:
This lube is to be done in conjunction
with previous lube requirements of this chapter.
Refer to the Lubrication chapter of this manual for
2000 hour Grease Point locations and other related
details.
STORAGE
If the Paver will NOT be operated for a long period of
time, prepare and store it using the procedures as fol-
lows.
BEFORE STORAGE
Perform the following prior to placing the Paver in
storage:
1. Wash off the entire machine.
2. Lubricate ALL grease points as described in the
Lubrication chapter of this manual.
3. Change Engine oil as outlined in the Service chap-
ter of this manual.
4. Apply grease to all exposed hydraulic cylinder rod
areas.
5. Disconnect the battery cable Clamps and cover the
Battery or remove the Battery from the Paver and
store it separately.
6. For 1649 Diesel Engine only. If the ambient tem-
perature (at anytime during the storage period) is
expected to drop below freezing, make sure the
Engine coolant is either completely drained from
the Radiator and Engine block or that the amount
of anti-freeze in it is adequate to keep the coolant
from freezing. Refer to the separate Engine manu-
al provided for anti -freeze recommendations and
quantities.
DURING STORAGE
1. About once each month, connect the Battery and
check ALL fluid levels to make sure they are at the
proper level BEFORE starting the Engine.
2. Start the Engine and allow it to run until it warms
up and then move the machine a short distance to
help relubricate the internal parts. Run the Engine
until the Battery has a chance to recharge and then
shut it off.
NOTE:
If it is desired to operate The hydraulic
cylinders at this time, BE SURE to wipe the pro-
tective grease (and any adhering dirt) from the
cyllnder rods prior to starting the Engine. After
operating, BE SURE to recoat the cylinder rods
with grease if the Paver is going to be returned to
storage.
AFTER STORAGE
After removing the Paver from storage and BEFORE
operating it, perform the following:
1. Change Engine oil and Filter to remove condensa-
tion or other residuals.
2. Wipe off grease from cylinder rods.
3. Lubricate ALL grease fittings.
4. Review and refamiliarize yourself with all safety
precautions as outlined in the Safety chapter of this
manual.
5. Follow the starting and warm-up procedures as
outlined in the Operation chapter of this manual.
Printed In U.S.A.
53
907389/AP297
Discount-Equipment.com