Gehl PowerBox 1639, Руководство оператора

Страница: 48 / 66

CHECK SCREED BOTTOM PLATE
The bottom plate of the Screed should be inspected
for possible wear.
NOTE:
Perform all other service requirements
up to this point as well as the following.
CHANGE ENGINE OIL
Change the Engine Oil using the following procedure:
1. With the Engine warm, remove the crankcase
Drain Plug. Some plugs are equipped with a mag-
net to gather metal particles. Completely clean and
flush away all metallic filings from the Plug and
re-install it.
NOTE:
DO NOT discharge onto ground. Catch
and dispose of per local waste disposal regula-
tions.
2. After new oil has been added, run the Engine at
idle speed until the oil pressure light is OFF (1649
models). Check for leaks at the Drain Plug. Re-
tighten only as much as necessary to eliminate
leakage.
CHECK TORQUE HUBS OIL LEVEL
With the Hopper raised, position the Track so the
Check Plug is in “3 or 9 o’clock” position. Plug is
located on the side opposite the Drive Motor. Loosen
Plug. If oil appears, re-tighten as level is sufficient.
LUBRICATE 250 HOUR GREASE POINTS
NOTE:
This lube is to be done in conjunction
with previous lube requirements of this chapter.
CHANGE ENGINE OIL FILTER
The Engine Oil Filter should be changed at every other
oil change interval. Remove and discard the throw
away Filter canister. Wipe the gasket and sealing area
of the block with a clean cloth.
NOTE:
Use only genuine OEM Engine replace-
ment Filters.
Fig. 16
1
. Fuel Filter (1649 Diesel)
2.
Fuel Pump (1649 Diesel)
3.
In-Line Filter (1639 Gas)
Service Every 250 Hours
1639 MODEL
FUEL
RESERVOIR
1 2
3
INJECTORS
1649 MODEL
FUEL
RESERVOIR
FUEL PUMP
Service Every Season or 500 Hours
Apply a thin coat of clean oil to the new Oil filter
Gasket. Spin tighten. Refill the crankcase with new oil.
Follow specifications in the Lubrication chapter for
type and viscosity of new oil to put in.
CHANGE FUEL FILTER (Fig. 16)
The frequency of Filter replacement will be deter-
mined by the cleanliness of available fuel, the care
used in storing fuel supplies and the operating condi-
tions in which the Paver is used.
NOTE:
For proper replacement procedures refer
to the Engine Manual for your machine.
Gas Engine (1639 Models) Filters
The Gas Engine has two Filters; (1) an In-Line Filter
just off the Fuel Reservoir, and (2) a Sediment Bowel
on the Engine Fuel Pump.
907389/AP297
50
Printed In U.S.A.
Discount-Equipment.com