Gehl PowerBox 1639, Руководство оператора

Страница: 18 / 66

Fig. 5 - Travel Controls
1.
Left Track Travel
3.
Pump Speed
2.
Right Track Travel
4.
Modular Steering
Hydraulic Fluid Reservoir: The Access/Fill Plug on
top may be removed to check fluid level..
NOTE:
Before removing the Access/Fill Plug,
allow the fluid to cool for 10-15 minutes. Take a
wrench and slowly loosen the Hydraulic Breather
Cap on the Backwall Top Console to release sys-
tem pressure.
Paving Alignment Guide: This is adjustable so the
Chain will align with a curb or the edge of a previous-
ly laid mat of asphalt..
TRAVEL CONTROLS (Figs. 5-6)
These controls are used to manuver the Paver around
on the jobsite or for road travel. Decals on the
Backwall Top Console area provide graphic represen-
tation of the various control actions.
Hydraulic Pump Variable Speed: This Lever
increases or decreases power to the Drive Motors. Push
the Lever FORWARD to increase speed, pull BACK to
decrease speed. Place the Lever in neutral when not
operating.
Track Travel: These two Levers control the Track
Drive Motors for forward and rearward movement and
also turning of the Paver. Both Levers are mechanical-
ly linked to Levers on the right side for control from
either side.
NOTE:
“Right” and “left” are determined from a
position standing behind the unit and facing the
direction of forward travel. Pivot the machine at
slow speeds only.
Movement of the Travel Levers and the expected
results are as follows
(See Fig. 6):
Move both Levers FORWARD to go forward. Move
both Levers REARWARD to go backwards. Move the
LEFT Track Lever FORWARD to pivot turn right.
Move the LEFT Track Lever REARWARD to pivot
turn left.
Move the RIGHT Track Lever FORWARD to pivot
turn LEFT. Move the RIGHT Track Lever REAR-
WARD to pivot turn right.
Move both Levers in opposite directions to spin the
machine about its center position. Returning both
Levers to “neutral” position stops the Drive Tracks.
4
3
RT. SIDE CONTROL
1 2
1 2
Printed In U.S.A.
19
907389/AP297
Discount-Equipment.com