GE MDS entraNET 900, Техническое руководство

Страница: 57 / 220

05-4055A01, Rev. E MDS entraNET Technical Manual 47
Figure 3-14. IP Configuration Menu
When static IP addressing is used, the user must manually configure the
IP address and other parameters. When dynamic addressing is used, the
radio uses a
Dynamic Host Configuration Protocol (DHCP) Client
process to obtain an IP address from a DHCP Server, along with other
parameters such as a net mask and a default gateway.
CAUTION:
Changing any of the following parameters while
communicating over the network (LAN or over-the-air) might
cause a loss of communication with the unit being configured.
You will need to reestablish communication using the new IP
address.
•
IP Address Mode
—Defines how the IP address of this device is
obtained: either statically configured, or dynamically assigned
from a DHCP server. [
Static, Dynamic; Static
]
•
Static IP Address
—( We recommend that you review this setting. )
Essential for connectivity to the transceiver MS using the LAN
port, and to encapsulate serial data over an IP. Enter any valid IP
address that is unique within the network. [
192.168.1.1
]
This field is unnecessary if you enable DHCP.
•
Static IP Netmask
—The IPv4 local subnet mask. This field is
unnecessary if DHCP is enabled. [
255.255.0.0
]
•
Static IP Gateway
—The IPv4 address of the network gateway
device, typically a router. This field is unnecessary if DHCP is
enabled, or if all devices are on the same subnet. [
0.0.0.0
]
•
Current IP Address
—( We recommend that you review this
setting. ) Displays the IP address.
•
Current IP Netmask
—Displays the IPv4 local subnet mask.